Our chrome wire shelving assembles easily without tools.(View Assembly Guide PDF or Assembly Guide Video) Open wire construction and high visibility chrome finish allows light to reflect off the shelving and brightens the room. Posts are marked with double grooves every 5" for ease of assembly and adjust easily on 1" increments. Starter units come with 4 shelves and 4 posts with leveling feet. Each shelf is rated for 500- 800 lb. per shelf capacity, evenly distributed.
|
Benefits:
- The Shelving Store has the largest chrome wire shelving selection available
anywhere
- Exceptional strength and durability (hold up to 800 lbs)
- Easy and quick assembly (no tools needed)
- Open wire design allows for excellent product visibility and air circulation
for less dust
- Fully adjustable every 1 inch (25mm) for best use of space
- Easy to wipe clean with snag-free surfaces
- Stationary or mobile options
- Free standing floor supported models or wall mounted systems
- Radiant chrome plated finish offers bright, clean and modern feel
- Wide range of accessories available, including side ledges, adjustable
dividers, retaining panels on backs and sides
- Posts are marked with double grooves every 5" for ease of assembly and
adjust easily on 1" increments
- NSF Approved
Assembly Guide:
 |
|
|
|
|
Chrome Wire Shelving Assembly Instructions:
|
 |
 |
 |
 |
First decide whether you would like the wheels or chrome stubs for the legs of the shelving unit. If using the chrome stubs, attach the chrome stubs to the bottom of each pole. Follow by attaching the chrome pegs. If you wish to use the wheels for a mobile shelving unit, simply attach the wheels to the bottom of the poles instead of the stubs and pegs. Remember, you can always switch the pegs for wheels if you later need more mobility from your shelving unit. |
 |
Once your base is complete, now you will add the shelves. Use 4 snap-on sleeves and snap them onto the very bottom of the four legs. Slide the first shelf onto the four poles, stopping when the shelf hits the snap-on sleeves. Using a rubber mallet, gently pound the shelf to ensure a tight fit. |
 |
 |
 |
Place 4 snap-on sleeves at a desired level above the previous shelf. Slide on the shelf and pound with a rubber mallet. Repeat a second time for the third shelf. |
 |
Use the last 4 snap-on sleeves by snapping them onto the very top of the four poles. Place the fourth and final shelf onto the sleeves and pound with a rubber mallet.. |
 |
 |
Your shelving unit is finished and ready for use! |
 |
 |
 |
|
|
